Eclipse Cross Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all,

Just recently got myself a 18 plate Eclipse Cross (UK).

Loving it so far, however, one of the things i'd like to do is hardwire a dashcam into the passenger side fuse box.

I currently cannot remove the trim from the passenger side A pillar. Don't want to pull it too hard incase it breaks so not sure if there is a process to go through to get it off without damage.

My previous car (Mazda 3) was easy, you just popped it off and back on again and could run the wire from the fuse box, up the pillar and into the head trim.

Thanks

Liam
 

·
Registered
Joined
·
134 Posts
Hi all,

Just recently got myself a 18 plate Eclipse Cross (UK).

Loving it so far, however, one of the things i'd like to do is hardwire a dashcam into the passenger side fuse box.

I currently cannot remove the trim from the passenger side A pillar. Don't want to pull it too hard incase it breaks so not sure if there is a process to go through to get it off without damage.

My previous car (Mazda 3) was easy, you just popped it off and back on again and could run the wire from the fuse box, up the pillar and into the head trim.

Thanks

Liam
Just use a plastic prybar to peel it away from the top and pull it away with finger tips. Comes away easy, but will be secured to the A pillar with plastic security device to keep it from hiitng you in the face in an accident
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top