Eclipse Cross Forum banner

Mud Flaps

8K views 11 replies 6 participants last post by  Sicoupe06 
I have a full set. The fronts required 2 holes per side. I shortened 1 of the screws on each side where its next to the body. The instructions didnt say to put one there, but it didnt make sense without one there.
For the rear, nothing to drill.

Note: with the extra thickness the push pin clips are very difficult to get put back in. You need to somehow compress the layers of plastic so you can push the pin in. I broke one of the back tabs off of one as i didnt have the plastic compressed enough.

I ordered mine here: https://www.ebay.com/itm/264091657595

If you want pics of the completed install, I can get them for you, just not sure how quick I can. Heading to vacation in the morning.
 
While you are correct that most do not require drilling and the set I received did contain self tapping screws, it also contained self tapping screw nuts (https://www.pedparts.co.uk/c/products/RAW/Universal_Self_Tapping_Screw_Speed_Nut.jpg ) which is far superior to just relying on a screw into plastic. Therefore drilling should be done. And in the case of the front of the EC, the lower mount has no place for it so a small slot must be created also.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top